Modern farmhouse with red, green and blue Christmas EverLights and a lit three-car garage.

New construction

Building a Home? Plan the Lights Now

The cleanest permanent lighting installs start before the drywall goes up. A little planning during construction puts power exactly where it is needed and hides the wiring for good.

Why plan during construction

Permanent lighting needs power at the roofline. In a finished home that can mean running wire through finished walls or along the exterior. While the walls are open, the same wire disappears inside them, and an outlet can go exactly where the power supply and controller will live.

The result: no visible conduit, no patched drywall and a system that looks like it was always part of the house.

Daytime view of a stone entry with EverLights installed in trim-matched channel, nearly invisible.
Installed and nearly invisible by day. EverLights installation example.

What gets planned

  • The power supply and controller location, near an outlet and within Wi-Fi range. Often the garage or an exterior wall.
  • Feed runs to the roofline. EverLights uses 2-wire feed cable from the power supply to where each light run starts. 14/2 is preferred, since heavier wire carries power more efficiently.
  • Where each run starts and ends, so long rooflines and separate sides of the house are powered the right way.
  • Future zones, such as a detached shop or a backyard pergola, that can join the system later with a wireless receiver.

Planning the lighting design

We review the plans or walk the framed house with you or your builder and decide which rooflines to light: every edge, or just the street-facing side and the most visible peaks. That design sets where the wiring goes.

The lights themselves can be installed when the exterior is finished, or later when you are ready. Planning now simply makes that installation clean.

Modern three-story home with soft white EverLights along each roof level.
Soft white lighting on every level of a modern three-story home. EverLights installation example.

What it costs

Planning and wiring are quoted with your project, and the lights are priced per linear foot like any other installation. See pricing by product line.

New construction FAQ

Why plan permanent lighting during construction?

Before insulation and drywall, it is easy to run power-supply feed wire to the roofline and put an outlet exactly where the power supply and Bridge will live. Afterward, the same wiring means more patching or visible conduit.

When should the wiring go in?

Ideally after framing and before insulation and drywall. We plan the runs with you or your builder, then come back to install the lights once the exterior is finished.

What wire does EverLights use?

EverLights power runs use 2-wire feed cable. Heavier wire carries power more efficiently, so 14/2 is preferred and the length of each feed run counts toward how many feet of lights a power supply can drive.

Where do the power supply and Bridge go?

Near an outlet and within Wi-Fi range, often in the garage or on an exterior wall. On a larger home, a second power supply or wireless receiver may be planned for another part of the roofline.

Do I have to buy the lights during construction?

No. Planning the wiring prepares the home. The lights can be installed once the exterior is finished, or later when you are ready.

How is it priced?

Planning and wiring are quoted with your project, and the lights are priced per linear foot like any other installation.

Building a Home? Plan Your Lighting Now

Tell us about your build and we'll plan power and wiring for permanent lighting.